Electric Dryer Installation Check
Do you need to verify an electric dryer was installed properly? Review the lists below for items we recommend you check.
Proper Installation Space?
In the installation area, allow at least 1 inch (2.5 cm) of clearance on both sides and approximately 5” from the rear of the appliance and the wall for power cord and vent hose clearance.
Proper Floor Condition?
Is the floor sturdy and level? To minimize noise and vibration, install the dryer on a level, solidly constructed floor capable of supporting the unit without flexing or bouncing. Installing on carpet or soft tile is not recommended.
Available venting?
Ensure there is access to proper venting in the installation area. Ducting to the outside of the home.
Proper Power Supply?
Ensure the power outlet is supplying 240Vac +/- 10% to the washer and is on a dedicated 30 Amp Circuit.
Water Supply Available?
Make sure the customers water supply can supply 20-120PSI to the unit...not necessary if not a “steam” model.
- Ensure all external shipping material has been removed from the unit.
- Verify that the unit is free from dents/scratches/other cosmetic imperfections
- Before moving the dryer, ensure it can pass through all doorways and narrow openings.
- Ensure the unit is properly wired at the terminal block, use either 3 wire or 4 wire power cord per your application. #10 AWG-minimum copper conductor power cord through the strain relief.
- Check to make sure the water line connection is correct installed and leak free. (Steam Models only).
- Use the proper venting construction. Rigid or Semi-Ridged venting material is recommended. Make sure no kinks or crushed venting occurs when the unit is pushed back into the final installation. Final length should be as short as possible, with as few elbows as possible, (subtract 6’ for each 90° elbow, do not use more than four elbows, (4 elbows = approximately 22’~28’).
- Is the dryer being stacked on the washer? Ensure all brackets and mounting screws are properly installed and secure.
- Is the unit being installed on a pedestal? Pedestal should be leveled prior to washer being set on top. Legs on the washer should be screwed in all the way. All 16 screws should be installed into the brackets.
- Properly Level the unit. A carpenter's level can be used across the top of the appliance (Use the leveling legs to level the unit. Leveling legs should all be contacting the floor.
- Make sure the lint filter is installed.
- Make sure the unit is powered on. (Display and lights should be functional)
- Run an Installation Test. Make sure the drum is empty and the unit is cool. Press and hold the Temp button and Signal button then while holding press Power to enter InS (Install Mode). InS should show on the display. The unit will start the test; it will last a few minutes. If the exhaust system is severely restricted, the Flow Sense LED will turn on. If it does not, then the system is clear and ready for use. Note: Different models may use different button combinations to enter installation mode. If (Temp + Signal) does not work for you model, check the owner's manual for the correct button combination for your model.
Related Videos
Dryer Install
Venting Tips
Install Test
INSTALLATION CHECKLISTS
Front Load Washer
Top Load Washer
Dryer
Refrigerator
