Top Load Washer Installation Check
Do you need to verify a top load washer was installed properly? Review the lists below for items we recommend you check.
Proper Installation Space?
In the installation area, allow at least 1 inch of clearance on both sides and 4~5.25 inches between the back of the appliance and the wall for waterline and power cord and drain hose clearance.
Proper Floor Condition?
Is the floor sturdy and level? To minimize noise and vibration, install the washer on a level, solidly constructed floor capable of supporting the washer without flexing or bouncing. Installing on carpet or soft tile is not recommended.
Water Supply Available?
If the unit has a water valve hookup, make sure the customers water supply is adequate and able to supply 20-120PSI to the unit.
Proper Access to Power?
LG Recommends The power outlet must be within 60 inches (1.5 m) of either side of the washer.
Proper Power Supply?
Ensure the power outlet is supplying 120Vac +/- 10% to the washer and is on a dedicated 15Amp Circuit.
Proper Drain?
Ensure that a proper stand off pipe or other appropriate drain is available. The Standpipe should not be lower than 24 inches and not higher than 96 inches from the bottom of the appliance.
- Ensure all external shipping material has been removed from the unit.
- Verify that the unit is free from dents/scratches/other cosmetic imperfections
- Before moving the washer, ensure it can pass through all doorways and narrow openings.
- Ensure the unit is properly plugged into the 120Vac outlet. It is not recommended to use a power strip or add other appliances to the outlet.
- Check to make sure the water line connections are correct (Hot to Hot, and Cold to Cold), opened, secure and leak free. (It is not recommended to use flood safe water lines).
- Properly Level the unit. A carpenter's level can be used across the top of the appliance (Use the leveling legs to level the unit. Leveling legs should all be contacting the floor.
- Make sure the drain hose is no deeper in the Standoff pipe than 4” if the drain hose is deeper, it may cause a backflush situation, a slow drain or no drain situation and could possibly give an IE error code.
- Make sure the unit is powered on. (Display and lights should be functional)
- Run Test Mode before leaving the home. Check for leaks, vibrations, abnormal noises during Test Mode to validate all components are functioning properly.
Related Videos
Top Load Washer Install Video
INSTALLATION CHECKLISTS
Front Load Washer
Top Load Washer
Dryer
Refrigerator
